HP ProCurve 530 NA (J8986A) User Manual

9-140
Command Line Reference
Adaptive Tx Power Control Commands
Adaptive Tx Power Control Commands
The commands described in this section configure parameters for Adaptive
Tx Power Control.
atpc
This command enables and disables Adaptive Tx Power Control on the
selected radio.
Syntax
[no] atpc
• no - Disables on the selected radio.
Default Setting
Disabled
Command Mode
Interface Configuration (Radio)
Command Function Mode Page
[no] atpc
Enables and disables Adaptive Tx Power
Control on the selected radio. (The
default is Disabled.)
IC-R 9-140
[no] atpc avoid-other-aps
Enables and disables the Avoid Other APs
function. (The default is Disabled.)
IC-R 9-141
[no] atpc rf-group-name
<name>
The name used to group APs for Adaptive
Transmit Power Control. (The default is
blank.)
IC-R 9-141
atpc adapt < ap | ap+clients >
Chooses between AP mode and
AP + Client mode.
IC-R 9-142
atpc max-reduction
<max-
reduction>
The maximum amount of power
attenuation, from 0-18dB. (The default is
18dB.)
IC-R 9-143
show atpc
Shows the current settings for ATPC.
GC 9-143

HP ProCurve 530 NA (J8986A) Specifications

General

Brand	HP
Model	ProCurve 530 NA (J8986A)
Category	Wireless Access Point
Language	English