9-147
Command Line Reference
VLAN Commands
1
Command Mode
Ethernet Interface Configuration
Example
Note You must not use the same VLAN ID for both a statically configured VLAN and
for a VLAN dynamically configured by a RADIUS server policy. If you dynam-
ically assign a VLAN that has already been statically assigned to a VLAN or to
the management VLAN or untagged VLAN, the dynamic authentication will
fail and will continue trying to authenticate.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# interface ethernet
ProCurve Access Point 530(ethernet)# management-vlan 9
ProCurve Access Point 530(ethernet)#
To Next Page
Loading...
