HP ProCurve 530 NA (J8986A) - Page 170

6-18
Wireless Interface Configuration
Configuring the Radio
Figure 6-5. Configuring B + G Modes [Advanced Radio Settings]
To Configure B + G Modes:
The setting, shown in Figure 6-5, allows both b stations and g stations to
associate with the AP.
1. Select Network Setup > Radio.
2. Click Status On to enable the radio.
3. Select IEEE 802.11g Mode.
4. Click the Edit button for Advanced Settings. A pop-up window for Advanced
Settings opens (see Figure 6-5).
5. Select Enable for Protected Mode, to set this radio parameter.
6. Select
[Update] to set the advanced radio parameters.