7-26
Wireless Security Configuration
Manual Configuration Using the CLI
Using the CLI to View the Current WLAN (BSS/SSID) Configuration.
The following example shows how to view the current configuration settings.
ProCurve Access Point 530# configure
ProCurve Access Point 530(config)# radio 1
ProCurve Access Point 530(radio1)# wlan 1
ProCurve Access Point 530(radio1-wlan1)# show wlan 1
WLAN #1 on Radio 1
Description insecure
Status Disabled SSID PR3_WLAN
VLAN 1 - Untagged BSSID 00:14:C2:A7:11:A0
DTIM Period 2
Security Type no-security (No Sec.) Closed System Disabled
MAC Auth Mode local deny-list only MAC Auth List not set
Authentication open-system only WEP Key Type ascii
WEP Key 1 akshjsnensitk WEP Key Size 128bit
WEP Key 2 not set Default Key WEP Key 1
WEP Key 3 not set
WEP Key 4 not set
WPA or WPA2 WPA and WPA2 WPA Cipher TKIP only
WPA Pre-auth. Disabled WPA Key Format ascii
WPA ASCII Key abcdefghijklmnop
WPA Hex Key not set
Web Authentication
Status Disabled Retry Limit 3
Username/Password Login Enabled Guest Login Enabled
Redirect URL www.procurve.com
Default Login Page Enabled
Default Login Failed Page Enabled
Default Welcome Page Enabled
RADIUS
Failover To Local Disabled Retransmit Num. 3
Primary Auth local (built-in) server Prim. Auth Port n/a
Prim. Auth Key n/a - using local (built-in) RADIUS server
Primary RADIUS MAC Authentication
MAC Password n/a - using local RADIUS MAC Addr. Format n/a
Secondary Auth local (built-in) server Sec. Auth Port n/a
Sec. Auth Key n/a - using local (built-in) RADIUS server
Secondary RADIUS MAC Authentication
MAC Password n/a - using local RADIUS MAC Addr. Format n/a
Primary Acct not set Prim. Acct Port 1813
Prim. Acct Key not set
Secondary Acct not set Sec. Acct Port 1813
Sec. Acct Key not set
ProCurve Access Point 530(radio1-wlan1)#
To Next Page
Loading...
