Huawei Quidway S9300 User Manual

Step 2 Run:
rmon prialarm entry-number prialarm-formula description-string sampling-interval
{ delta | changeratio | absolute } rising-threshold threshold-value1 event-entry1
falling-threshold threshold-value2 event-entry2 entrytype { cycle entry-period |
forever } [ owner owner-name ]
The prialarmTable is configured.
Based on the alarmTable in RFC 2819, the RMON prialarm management is enhanced with two
functions: setting the alarm object in the form of expressions and limiting the time to live (TTL)
value of a prialarm entry.
Compared with the alarmTable, the prialarmTable has several additional entries:
l Expression of alarm variables. It can be an arithmetic expression composed of the OIDs of
alarm variables, +, -, *, / or brackets.
l Description of the prialarm entry in a character string.
l Prialarm state period, in seconds. It must be larger than the sampling interval.
l Two prialarm state types: Forever or Cycle. If Cycle is set, an alarm does not occur and the
entry is deleted after the specified prialarm state period.
If the events that correspond to the alarm upper limit and lower limit (event-entry1, event-
entry2) are not configured in the eventTable, an alarm does not occur even if the alarm conditions
are satisfied. (The alarm record is in the undercreation state rather than in the VALID state.)
If either the alarm upper limit event or the alarm lower limit event is configured, the alarm is
triggered once the conditions for an alarm are satisfied. (The alarm record is in the VALID state.)
----End
2.3.8 Checking the Configuration
After configuring RMON, you can view the traffic statistics collected by RMON.
Prerequisite
The configurations of the RMON are complete.
Procedure
l Run the display rmon alarm [ entry-number ] command to view the RMON alarm
information.
l Run the display rmon event [ entry-number ] command to view the RMON events.
l Run the display rmon eventlog [ entry-number ] command to view the RMON event logs.
l Run the display rmon history [ ethernet interface-number | gigabitethernet interface-
number | xgigabitethernet interface-number ] command to view the RMON history
information.
l Run the display rmon prialarm [ entry-number ] command to view the information of the
RMON prialarmTable.
l Run the display rmon statistics [ ethernet interface-number | gigabitethernet interface-
number | xgigabitethernet interface-number ] command to view the RMON statistics.
----End
2 RMON and RMON2 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
2-10 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)

Huawei Quidway S9300 Specifications

General

Brand	Huawei
Model	Quidway S9300
Category	Network Router
Language	English