NOTE
Only SNMPv2c support the Inform mode.
Pre-configuration Tasks
Before configuring the Informing mode, complete the following tasks:
l Assigning an IP address to the switch
l Configuring a routing protocol for the communication between the switch and the NM
Station
l Enabling the SNMP agent
l Configuring the SNMP version
Data Preparation
To configure the Informing mode, you need the following data.
No. Data
1 IP address of the destination and UDP port number to which the Informing messages
are sent, Virtual Private Network (VPN) instance name, security name, and security
level
2
l (Optional) Timeout period for waiting for the Informing ACK messages
l (Optional) Number of times to re-propagate alarms
l (Optional) Number of pending alarms (alarms waiting for being acknowledged)
3
l (Optional) Aging time of alarm logs
l (Optional) Limit pieces of alarm logs
1.18.2 (Optional) Enabling the switch to Send Specified Alarms to
the NM Station
Context
Do as follows on the switch enabled with the SNMP agent:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent trap enable
The switch is enabled to send alarms.
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-62 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
