Huawei Quidway S9300

Procedure
Step 1 Run the display nqa results command to view the test results on the NQA client.
----End
Example
Run the display nqa results command. If the test is successful, the following is displayed.
l Statistics about errors
– Number of unroutable connections
– Number of wrong sequence numbers
– Timeout times of the test packets
l History statistics of each test packet
– Timestamp added when each test packet is sent
– Timestamp added when each test packet is received
– Packets status displayed on the NQA client
l Statistics of results of each test
– Number of successful tests
– Sum of the response time of all tests
– RTT square sum
– Minimum RTT and maximum RTT of the packet
– Destination IP address and the type of the destination IP address
– Number of the Echo packets and the sent packets
– Time when the last packet is received
<Quidway> display nqa results
NQA entry(admin, pwe3ping) :testflag is inactive ,testtype is pwe3ping
1 . Test 1 result The test is finished
Send operation times: 3 Receive response times: 3
Completion:success RTD OverThresholds number: 0
Attempts number:1 Drop operation number:0
Disconnect operation number:0 Operation timeout number:0
System busy operation number:0 Connection fail number:0
Operation sequence errors number:0 RTT Stats errors number:0
Destination ip address:8.1.1.2
Min/Max/Average Completion Time: 4/6/5
Sum/Square-Sum Completion Time: 16/88
Last Good Probe Time: 2009-2-28 11:2:46.8
Lost packet ratio: 0 %
6.27 Configuring the PWE3 Trace Test to Check the One-
Hop PW
This section describes how to configure a PWE3 trace test to check the communications between
devices along a PW.
6.27.1 Establishing the Configuration Task
Before configuring a PWE3 trace test for a single-hop PW, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-101