Max Negative SD:0 Max Negative DS:0
Negative SD Number:0 Negative DS Number:0
Negative SD Sum:0 Negative DS Sum:0
Negative SD Square Sum :0 Negative DS Square Sum :0
Min Delay SD:0 Min Delay DS:0
Avg Delay SD:0 Avg Delay DS:0
Max Delay SD:0 Max Delay DS:0
Packet Loss SD:0 Packet Loss DS:0
Packet Loss Unknown:0 Average of Jitter:0
Average of Jitter SD:0 Average of Jitter DS:0
jitter out value:0.0000000 jitter in value:0.0000000
NumberOfOWD:0 OWD SD Sum:0
OWD DS Sum:0 RTT average: 0
Packet Loss Ratio: 0 MOS-CQ value:0.00
ICPIF value:0
6.16 Configuring the LSP Ping Test
This section describes how to configure a Label Switched Path (LSP) ping test to check the
operating status of the LSP.
6.16.1 Establishing the Configuration Task
Before configuring an LSP ping test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
6.16.2 Configuring the LSP Ping Test Parameters for the LDP Tunnel
Before performing an LDP LSP ping test, you need set parameters for the LSP ping test.
6.16.3 Configuring the LSP Ping Test Parameters for the MPLS TE Tunnel
Before performing the TE LSP ping test, you need set parameters for a TE LSP ping test.
6.16.4 Configuring the LSP Ping Test Parameters for the CR-LSP Hotstandby Tunnel
Before performing the LSP ping test, you need set LSP ping test parameters for CR-LSP tunnels
in hot standby mode.
6.16.5 Checking the Configuration
After configuring the LSP ping test, you can view the test result.
6.16.1 Establishing the Configuration Task
Before configuring an LSP ping test, familiarize yourself with the applicable environment,
complete the pre-configuration tasks, and obtain the required data. This can help you complete
the configuration task quickly and accurately.
Applicable Environment
The NQA LSP Ping test can be used to test the reachability of the following types of Label
Switched Paths (LSPs) and collect statistics about Link State Advertisement (LSA).
l LSP tunnels
l MPLS TE tunnels
l MPLS CR-LSP hotstandby tunnels
After the test parameters are configured and the test is started,
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-45
To Next Page
Loading...
Need help?
General
