Exit from the test instance view.
----End
6.23.5 Starting the NQA MTrace Test
This part describes how to start the MTrace test instance to perform the MTrace test for the RPF
path from the multicast source to the destination host.
Context
Do as follows on the switch that functions as the NQA client:
NOTE
The start mode of the MTrace test is the same as that of other NQA tests. Here, take one mode as an example.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
start now
The NQA MTrace test is started.
Step 4 Run:
quit
Exit from the test instance view.
----End
6.23.6 Setting Policies for Filtering Queriers
You can set policies to filter queriers only on the last-hop that receives the unicast IGMP Tracert
Query packet.
Context
Do as follows on the switch connected to the host:
NOTE
The settings in this step take effect only on the last-hop switch that receives the unicast IGMP Tracert-
Request packet.
Procedure
Step 1 Run:
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-86 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
