Huawei Quidway S9300

Select the start mode as required because the startcommand has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To perform the NQA test after a certain delay period, run the start delay { seconds second
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
----End
6.19.3 Checking the Configuration
After configuring the ICMP jitter test, you can view the test result.
Prerequisite
The configurations of the ICMP Jitter Test function are complete.
NOTE
NQA test results cannot be displayed automatically on the terminal. You should run the display nqa
results command to check the test results.
Procedure
Step 1 Run the display nqa results [ test-instance admin-name test-name ] command to check results
on the NQA client.
----End
Example
If the ICMP jitter test succeeds, you can view the following information by running the display
nqa results command.
<Quidway> display nqa results test-instance admin icmpjitter
NQA entry(admin, icmpjitter) :testFlag is inactive ,testtype is jitter
1 . Test 1 result The test is finished
SendProbe:60 ResponseProbe:60
Completion :success RTD OverThresholds number:0
OWD OverThresholds SD number:0 OWD OverThresholds DS number:0
Min/Max/Avg/Sum RTT:1/144/12/709 RTT Square Sum:61007
NumOfRTT:60 Drop operation number:0
Operation sequence errors number:0 RTT Stats errors number:0
System busy operation number:0 Operation timeout number:0
Min Positive SD:1 Min Positive DS:1
Max Positive SD:138 Max Positive DS:3
Positive SD Number:7 Positive DS Number:19
Positive SD Sum:152 Positive DS Sum:21
Positive SD Square Sum :19116 Positive DS Square Sum :27
Min Negative SD:1 Min Negative DS:1
Max Negative SD:21 Max Negative DS:4
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-67