Huawei Quidway S9300

7.6.2 Creating a Record and Entering the Record View
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream record record-name
A record is created and the record view is displayed.
----End
7.6.3 Configuring Aggregation Key Words of Records
Context
Do as follows on the S9300 where the Flexible NetStream feature needs to be configured.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream record record-name
The record view is displayed.
Step 3 Run:
match ip { destination-address | destination-port | dscp | flow-label | protocol |
source-address | source-port }
The aggregation key words of records are configured.
NOTE
The flow-label parameter is applicable to only the IPv6 traffic.
----End
7.6.4 (Optional) Configuring the Exported Traffic Statistics
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream record record-name
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 7 NetStream Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7-17