Huawei Quidway S9300 User Manual

Step 6 (Optional) Perform the following as required to configure other parameters for the LSP
Traceroute test:
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the response mode of the Echo packet, run the lsp-replymode { no-reply |
udp | udp-via-vpls | udp-router-alert | level-control-channel } command.
NOTE
In a uni-directional LSP Traceroute test, if the lsp-replymode no-reply command is configured, the
test result displays that the test fails regardless of whether the test is successful or fails. If the test is
successful, the test result also displays the number of the timeout packets. If the test fails, the test result
displays the number of the discarded packets.
l To configure the LSP EXP value, run the lsp-exp exp command.
l To configure after how many hops a test is considered failed, run the tracert-hopfailtimes
times command.
l To configure the initial and the maximum TTL values of the packet, run the tracert-
livetime first-ttl first-ttl max-ttl max-ttl command.
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To perform the NQA test after a certain delay period, run the start delay { seconds second
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
----End
6.18.4 Configuring the LSP Traceroute Test Parameters for the CR-
LSP Hotstandby Tunnel
This part describes how to set LSP traceroute test parameters for CR-LSP hot standby tunnels.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-61

Huawei Quidway S9300 Specifications

General

Brand	Huawei
Model	Quidway S9300
Category	Network Router
Language	English