Procedure
Step 1 Run the display netstream all command to view the NetStream configuration.
----End
7.6 Configuring the Flexible NetStream Feature
This section describes how to configure the Flexible NetStream feature to flexibly create
NetStream statistics according to records.
7.6.1 Establishing the Configuration Task
7.6.2 Creating a Record and Entering the Record View
7.6.3 Configuring Aggregation Key Words of Records
7.6.4 (Optional) Configuring the Exported Traffic Statistics
7.6.5 Configuring NetStream and Setting the Packet Sampling Ratio
7.6.6 Enabling Flexible NetStream on Interfaces
7.6.7 Checking the Configuration
7.6.1 Establishing the Configuration Task
Applicable Environment
To collect statistics on packets based on the protocol type, DSCP field, source IP address,
destination IP address, source port number, destination port number, or traffic label on the IP
network, you can configure Flexible NetStream.
Pre-configuration Tasks
Before configuring Flexible NetStream, complete the following task:
l Setting physical parameters on interfaces
Data Preparation
To complete the configuration, you need the following data.
No.
Data
1 Name and number of the interface on which
traffic statistics need to be collected
2 IP addresses and port numbers of the NSC
7 NetStream Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
7-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
