The NetStream aggregation view is displayed.
Step 3 (Optional) Run:
ip netstream export source ip-address
The source address for exporting statistics is configured.
Step 4 Run:
ip netstream export host ip-address port-number
The destination address for exporting statistics is configured.
The destination NSC address of the exported statistics can be configured in either the system
view or the NetStream aggregation view.
The priority of the destination NSC address configured in the NetStream aggregation view is
higher than that configured in the system view. After the destination NSC address is successfully
configured,
l Original traffic can only be sent to the destination NSC address configured in the system
view.
l Aggregation traffic is sent to the destination NSC address configured in the NetStream
aggregation view.
If no destination NSC address is configured in the NetStream aggregation view, aggregation
traffic is sent to the destination NSC address configured in the system view.
----End
7.5.5 Configuring the Aggregation Function
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ip netstream aggregation { as | as-tos | destination-prefix | destination-prefix-
tos | prefix | prefix-tos | protocol-port | protocol-port-tos | source-prefix |
source-prefix-tos }
The NetStream aggregation view is displayed.
Step 3 Run:
enable
The aggregation mode is enabled.
----End
7.5.6 Checking the Configuration
Prerequisite
All configurations are complete.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 7 NetStream Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
7-15
To Next Page
Loading...
Need help?
General
