2 RMON and RMON2 Configuration
About This Chapter
This chapter describes how to monitor the Ethernet interface through Remote Network
Monitoring (RMON) and Remote Network Monitoring Version 2 (RMON2).
2.1 Introduction to RMON and RMON2
This part describes working principles of and differences between RMON and RMON2.
2.2 RMON and RMON2 Suported by the S9300
This part describes the support for RMON and RMON2 on the S9300.
2.3 Configuring RMON
This section describes how to monitor the network status and traffic through RMON.
2.4 Configuring RMON2
This section describes how to configure RMON2 to monitor the traffic of a certain interface,
analyze the source and destination of data transmitted through the interface, and collect the
statistics on the data of each host that passes through the interface.
2.5 Maintaining RMON and RMON2
When an RMON operation fault occurs, you can run the debuggingcommand in the user view
to locate the fault and analyze its cause.
2.6 Configuration Examples
This section provides several configuration examples of RMON and RMON2.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 2 RMON and RMON2 Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2-1
To Next Page
Loading...
