Huawei Quidway S9300

Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent sys-info version v3
The SNMP version is configured.
By default, SNMPv3 is configured.
----End
1.9.4 Configuring an SNMP User Group
This part describes how to create an SNMP access user group.
Context
Do as follows on the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent group v3 group-name
An SNMP user group is configured.
----End
1.9.5 Configuring User Information
After user information about the NM Station is configured, you can configure NM Station users
in a specific group to access the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-26 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)