Huawei Quidway S9300

If a test instance fails, you can try to restart the test instance in the next test period.
6.36.2 Clearing NQA Statistics
When the statistics on the current test instance are saved to the FTP server, you can clear test
results on the device.
6.36.3 Debugging NQA
This part describes how to debug test instances.
6.36.1 Restarting NQA Test Instances
If a test instance fails, you can try to restart the test instance in the next test period.
Prerequisite
To restart an NQA test instance, run the following command in the NQA instance view.
Context
CAUTION
Restarting an NQA test instance interrupts the running of tests.
Procedure
Step 1 Run the system-view command, enter the system view.
Step 2 Run the nqa test-instance admin-name test-name command, enter the NQA test instance view.
Step 3 Run the restart command in the NQA instance view to restart an NQA test instance.
----End
6.36.2 Clearing NQA Statistics
When the statistics on the current test instance are saved to the FTP server, you can clear test
results on the device.
Context
CAUTION
NQA statistics cannot be restored after you clear them. So, confirm the action before you use
the command.
NOTE
Statistics about the test being performed cannot be cleared.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-138 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)