Huawei Quidway S9300

The system view is displayed.
Step 2 Run:
snmp-agent usm-user v3 user-name group-name
User information is configured.
----End
1.9.6 Checking the Configuration
After basic functions of SNMPv3 are configured, you can view configurations of SNMPv3.
Prerequisite
The configurations of the basic functions of SNMPv3 are complete.
Procedure
l Run the display snmp-agent group [ group-name ] command to view information about
the SNMP user group.
l Run the display snmp-agent usm-user [ engineid engineid | group group-name |
username user-name ] * command to view information about users in the group.
l Run the display snmp-agent sys-info version command to view the SNMP version
information..
----End
Example
Run the display snmp-agent group command. If information on the user group is displayed, it
means that the configuration succeeds.
<Quidway> display snmp-agent group
Group name: a
Security model: v3 noAuthnoPriv
Readview: ViewDefault
Writeview: <no specified>
Notifyview :<no specified>
Storage-type: nonvolatile
Run the display snmp-agent usm-user command. If information on the SNMP user is displayed,
it means that the configuration succeeds.
<Quidway> display snmp-agent usm-user
User name: b
Engine ID: 000007DB7F00000100000772 active
Run the display snmp-agent sys-info version command. If the version of SNMP run on the
agent is displayed, it means that the configuration succeeds.
<Quidway> display snmp-agent sys-info version
SNMP version running in the system:
SNMPv3
1.10 Configuring Group-based Access Control in SNMPv3
After group-based access control in SNMPv3 is configured, only the NM Station users in the
specific group can access the device through SNMPv3.
1.10.1 Establishing the Configuration Task
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 1 SNMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-27