Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
lldp enable
LLDP is enabled globally.
----End
4.3.4 (Optional) Disabling LLDP on an Interface
When LLDP is enabled globally on an switch, all the interfaces are enabled with LLDP by
default. When only certain interfaces need the LLDP function, for the interfaces that do not need
the LLDP function, you can run the undo lldp enable command on these interfaces to disable
the LLDP function. Do as follows on SwitchA and SwitchB.
Prerequisite
LLDP has been enabled globally.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
undo lldp enable
LLDP is disabled on the interface.
----End
4.3.5 (optional) Configuring an LLDP Management Address
The LLDP management address is used by the NMS to identify devices and manage the network.
Do as follows on Switch A and Switch B.
Prerequisite
LLDP has been enabled globally.
Procedure
Step 1 Run:
system-view
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 4 LLDP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-7
To Next Page
Loading...
