Huawei Quidway S9300

1.18.6 (Optional) Configuring the Parameters for the Informing
Mode
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent inform { timeout seconds | resend-times times }
*
address udp-domain ip-
address [ vpn-instance vpn-instance-name ] params securityname security-string
The timeout period for the destination host to acknowledge Informing messages and the times
to re-send Inform messages are set.
By default, the timeout period for the destination host to acknowledge Informing messages is
15 seconds and the times to re-send Informing messages are set to 3.
----End
1.18.7 (Optional) Configuring the Logging Function for the
Informing Mode
If the switch and the destination host cannot communicate because of a link failure, the switch
no longer sends Inform messages to send traps but keeps generating trap logs. When the link
recovers, the switch updates trap logs recorded during the link failure to the host destination.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent notification-log enable
The alarm logging function is enabled.
After the alarm logging function is enabled, the system records the alarms propagated only
through the Informing mode.
By default, the alarm logging function is disabled.
Step 3 Run:
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 1 SNMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-65