Data Preparation
To configure the ICMP test, you need the following data.
No. Data
1 Administrator name and test name of the NQA test
2 Destination IP address
3 (Optional) Virtual Private Network (VPN) instance name, source interface that sends
test packets, source IP address, size of the Echo-Request packets, TTL value, ToS,
padding character, interval for sending test packets, and percentage of the failed NQA
tests
4 Start mode and end mode
6.5.2 Configuring ICMP Test Parameters
This part describes how to set ICMP test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type icmp
The test type is set to ICMP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other ICMP test parameters:
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
command.
l To configure the source interface that sends test packets, run the source-interface interface-
type interface-number command.
l To configure the source IP address, run the source-address ipv4 ip-address command.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-9
To Next Page
Loading...
