EasyManuals Logo

Huawei Quidway S9300 User Manual

Huawei Quidway S9300
630 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #528 background imageLoading...
Page #528 background image
l Run the display cluster candidates [ mac-address mac-address | verbose ] to check
information about candidate switches.
----End
8.4.3 Debugging HGMP
When a fault occurs on NDP, NTDP, or a cluster, you can run the debugging command in the
user view to debug NDP, NTDP, or the cluster, view debugging information, locate the fault,
and analyze the cause.
Context
CAUTION
Debugging affects the performance of the system. After the debugging, run the undo debugging
all command to timely disable it.
When a fault occurs on NDP, NTDP, or a cluster, run the debugging command in the user view
to debug NDP, NTDP or the cluster, and you can view debugging information, locate the fault,
and then analyze the cause.
For more information about the debugging command, refer to the Debugging Reference.
Procedure
l Run the debugging ndp packet [ interface { interface-type interface-number [ to
interface-type interface-number ] } &<1-10> ] command to enable NDP debugging.
l Run the debugging ntdp { all | data | error | message | packet [ verbose ] } to enable
NTDP debugging.
l Run the debugging cluster { all | event | handshake | member | mrc | nat | packet |
state } command or debugging cluster { packet | handshake | mrc } [verbose ] command
to enable cluster debugging.
----End
8.5 HGMP Configuration Examples
This section provides several configuration examples of HGMP.
8.5.1 Example for Configuring Basic HGMP Functions for a Cluster
8.5.2 Example for Configuring the Interconnection of FTP Servers and Devices in and out of
the HGMP Cluster (in NAT Mode)
8.5.3 Example for Configuring the Interconnection of FTP Servers and Devices in and out of
the HGMP Cluster (in Non-NAT Mode)
8.5.4 Example for Configuring Devices in the HGMP Cluster to Access the Outside SNMP Host
(in NAT Mode)
8.5.5 Example for Configuring Devices in the HGMP Cluster to Access the Outside SNMP Host
(in non-NAT Mode)
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-32 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S9300 and is the answer not in the manual?

Huawei Quidway S9300 Specifications

General IconGeneral
BrandHuawei
ModelQuidway S9300
CategoryNetwork Router
LanguageEnglish

Related product manuals