Before configuring MIB-view-based access control in SNMPv3, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
1.13.2 Configuring the SNMP Version
After the SNMP version is disabled on the device, to enable the NMS to access the device through
SNMPv3, you need to configure SNMPv3 on the switch.
1.13.3 Creating a MIB View
By configuring different MIB views, you can configure different access authorities for NM
Stations.
1.13.4 Configuring Authorities for the SNMP User Group
1.13.5 Configuring User Information
NM Station user information configured on the NM Station and the device must be identical.
Otherwise, the NM Station cannot access the device.
1.13.6 Checking the Configuration
After MIB-view-based access control in SNMPv3 is configured, you can view configurations
of the MIB and users.
1.13.1 Establishing the Configuration Task
Before configuring MIB-view-based access control in SNMPv3, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
When the user has a higher requirement for network security, configure MIB views on the USM
to set different NM Stations with corresponding management authorities.
Pre-configuration Tasks
Before configuring MIB views in the USM, complete the following tasks:
l Assigning an IP address to the switch
l Configuring the routing protocol to make the switch and the NM Station accessible
Data Preparation
To configure MIB views in the USM, you need the following data.
No.
Data
1 SNMP group name
2 SNMP user name
3 Information about MIB objects
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 1 SNMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-41
To Next Page
Loading...
