Huawei Quidway S9300 - Example for Configuring an ICMP Jitter Test; Figure 6-18 Networking Diagram of an ICMP Jitter Test

To Next Page

To Previous Page

6.37.16 Example for Configuring an ICMP Jitter Test

This part provides examples for configuring an ICMP jitter test to measure jitter on the network.

A server is not required in an ICMP jitter test and the peer device in the test instance can be non-

Huawei devices.

Networking Requirements

As shown in Figure 6-18,

Switch A serves as the NQA client to test the jitter of the network between Switch A and Switch

Figure 6-18 Networking diagram of an ICMP jitter test

SwitchA

GE1/0/0

SwitchB

VLANIF10

10.1.1.1/24

VLANIF10

10.1.1.2/24

Configuration Roadmap

The configuration roadmap is as follows:

1. Configure Switch A as the NQA client and create an ICMP jitter test instance on Switch

2. Configure Switch B as the NQA server.

Data Preparation

To complete the configuration, you need the following data:

l IP address of Switch B

Procedure

Step 1 Configure a reachable route between Switch A and Switch B.

The configuration details are not mentioned here.

Step 2 Configure an NQA test instance for Switch A.

# Enable the NQA client and configure the ICMP jitter test instance.

<RouterA> system-view

[RouterA] nqa test-instance admin icmpjitter

[RouterA-nqa-admin-icmpjitter] test-type icmpjitter

[RouterA-nqa-admin-icmpjitter] destination-address ipv4 10.1.1.2

Step 3 Start the test.

[RouterA-nqa-admin-icmpjitter] start now

Step 4 Check test results.

Quidway S9300 Terabit Routing Switch

Configuration Guide - Network Management 6 NQA Configuration

Issue 03 (2010-09-20) Huawei Proprietary and Confidential

6-179

Other manuals for Huawei Quidway S9300