#
sysname SwitchB
#
vlan batch 100 110
#
interface Vlanif100
ip address 10.1.1.2 255.255.255.0
#
interface Vlanif110
ip address 10.2.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
return
l Configuration file of Switch C
#
sysname SwitchC
#
vlan batch 110
#
interface Vlanif110
ip address 10.2.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 110
port hybrid untagged vlan 110
#
nqa-server udpecho 10.2.1.2 9000
#
ip route-static 10.1.1.0 255.255.255.0 10.2.1.1
#
return
6.37.11 Example for Configuring the MAC Ping Test
Networking Requirements
As shown in Figure 6-13:
l CFM is enabled on Switch A and Switch B.
l MAs and MDs are configured on Switch A and Switch B.
The NQA MAC Ping test is used to test the connectivity between Switch A and Switch B.
Figure 6-13 Networking diagram for configuring the MAC Ping test
SwitchA SwitchB
GE2/0/1 GE2/0/1
NQA Client
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-162 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
