Huawei Quidway S9300

3.3.8 (Optional) Setting the Maximum Number of Dynamic NTP
Sessions
Context
Do as follows on the S9300 that functions as a client.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ntp-service max-dynamic-sessions number
The maximum number of dynamic NTP sessions is set.
----End
3.3.9 Checking the Configuration
After basic NTP functions are configured, you can view the configuration.
Prerequisite
The configurations of the Basic NTP Functions are complete.
Procedure
l Run the display ntp-service status command to view the status of the NTP service.
l Run the display ntp-service sessions [ verbose ] command to view the status of NTP
sessions.
l Run the display ntp-service trace command to view the summary information on each
passing NTP server when tracing from the local device to the reference clock source.
----End
Example
Run the display ntp-service status command to view the status of the NTP service.
<Quidway> display ntp-service status
clock status: synchronized
clock stratum: 2
reference clock ID: LOCAL(0)
nominal frequency: 60.0002 Hz
actual frequency: 60.0002 Hz
clock precision: 2^18
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 0.00 ms
peer dispersion: 10.00 ms
reference time: 15:51:36.259 UTC Apr 25 2010(C6179088.426490A3)
Run the display ntp-service sessions [ verbose ] command to view the status of NTP sessions.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 3 NTP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-13