Huawei Quidway S9300

Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
alarm entry-number { lost-packet-ratio | jitter-average | jitter-ds-average |
jitter-sd-average | packet-loss-ds | packet-loss-sd | rtt-average } { absolute |
delta } { falling-threshold threshold-value1 event-entry1 | rising-threshold
threshold-value2 event-entry2 } * [ description description ]
The alarm number and the threshold are configured.
NOTE
At present, only the absolute statistics function rather than the relative statistics function is supported.
----End
6.35.4 Starting the Test Instance
You can start a test instance. When the number of test results exceeds the threshold,
corresponding action is taken.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To perform the NQA test after a certain delay period, run the start delay { seconds second
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
The test instance is started after a certain delay.
----End
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-136 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)