Group name:private
Acl:2000
Storage-type: nonVolatile
# When a trap is generated, you can run the display trapbuffer command to view details about
the trap.
[Switch] display trapbuffer
Trapping buffer configuration and contents : enabled
Allowed max buffer size : 1024
Actual buffer size : 256
Channel number : 3 , Channel name : trapbuffer
Dropped messages : 0
Overwritten messages : 0
Current messages : 1
#Feb 1 08:49:55 2009 Switch ENTMIB/4/TRAP:1.3.6.1.2.1.47.2.0.1 Entity MIB change.
----End
Configuration Files
The configuration file on the Switch is as follows:
#
sysname Switch
#
vlan batch 100
#
acl number 2000
rule permit source 1.1.1.1 0
#
interface Vlanif100
ip address 2.2.2.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 100
port hybrid untagged vlan 100
#
ospf 1
area 0.0.0.0
network 2.2.2.0 0.0.0.255
#
snmp-agent
snmp-agent local-engineid 000007DB7F000001000031E7
snmp-agent community read public acl 2000
snmp-agent community write private acl 2000
snmp-agent sys-info contact Mr.Wang-Tel:21657
snmp-agent sys-info location telephone-closet,2rd-floor
snmp-agent sys-info version v2c
snmp-agent target-host Trap address udp-domain 1.1.1.1 params securityname public
v2c
#
return
1.23.3 Example for Configuring Different NMSs to Access the
Switch
Networking Requirements
As shown in Figure 1-5, reachable routes exist between NMS1 and the Switch, and between
NMS2 and the Switch. The IP address of the interface connecting NMS1 to the network is on
1.1.1.1/24; the IP address of the interface connecting NMS2 to the network is on 1.1.1.2/24. The
IP address of the Ethernet interface connecting the Switch to the network is on 1.1.2.1/24.
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-78 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
