Huawei Quidway S9300 User Manual

6.9.2 Configuring the DNS Test Parameters
This part describes how to set DNS test parameters.
Context
Do as follows on the NQA client (DNS client):
Procedure
Step 1 Run
system-view
The system view is displayed.
Step 2 Run:
dns resolve
Enable dynamic DNS resolution. By default, the function is disabled.
Step 3 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 4 Run:
test-type dns
The test type is set to DNS.
Step 5 Run:
dns-server ipv4 ip-address
The IPv4 address of the DNS server is configured.
Step 6 Run:
destination-address url urlstring
The name of the destination host is configured.
Step 7 Run:
start
The NQA test is started.
Select the start mode as required because the start command has several forms.
l To perform the NQA test immediately, run the start now [ end { at [ yyyy/mm/dd ]
hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime { seconds second | hh:mm:ss } } ]
command.
The test instance is started immediately.
l To perform the NQA test at the specified time, run the start at [ yyyy/mm/dd ] hh:mm:ss
[ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } | lifetime
{ seconds second | hh:mm:ss } } ] command.
The test instance is started at a specified time.
l To perform the NQA test after a certain delay period, run the start delay { seconds second
| hh:mm:ss } [ end { at [ yyyy/mm/dd ] hh:mm:ss | delay { seconds second | hh:mm:ss } |
lifetime { seconds second | hh:mm:ss } } ] command.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-23

Huawei Quidway S9300 Specifications

General

Brand	Huawei
Model	Quidway S9300
Category	Network Router
Language	English