Huawei Quidway S9300 User Manual

NOTE
The querier must meet either of the following conditions:
l Connected to the destination host
l Pinging through the destination host or the last-hop switch
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
The test instance view is displayed.
Step 3 Run:
mtrace-source-address ipv4 ip-address
The address of the multicast source is specified.
Step 4 Run:
destination-address ipv4 ip-address
The IP address of the destination host is configured.
Step 5 (Optional)The VPN instance is specified.
vpn-instance vpn-instance-name
Step 6 Run:
quit
Exit from the NQA test instance view.
----End
6.23.4 (Optional) Adjusting the Performance of the NQA MTrace
Test
This part describes how to set optional MTrace test parameters according to the network
operating status.
Context
Do as follows on the switch with the MTrace test being configured:
NOTE
The steps described in this procedure are all optional.
Procedure
Step 1 Run:
system-view
The system view is displayed.
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-84 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)

Huawei Quidway S9300 Specifications

General

Brand	Huawei
Model	Quidway S9300
Category	Network Router
Language	English