Huawei Quidway S9300

ntp-service multicast-server [ authentication-keyid key-id | version number ]*
The ID of the authentication key used by the NTP multicast server is configured.
For configuring the multicast client, see Configuring the Broadcast Mode.
----End
3.4.8 Checking the Configuration
After NTP security mechanisms are configured, you can view the configuration.
Prerequisite
The configurations of the NTP Security Mechanisms are complete.
Procedure
l Run the display ntp-service status command to view the status of the NTP service.
l Run the display ntp-service sessions [ verbose ] command to view the status of NTP
sessions.
----End
Example
Run the display ntp-service status command to view the status of the NTP service.
<Quidway> display ntp-service status
clock status: synchronized
clock stratum: 2
reference clock ID: LOCAL(0)
nominal frequency: 60.0002 Hz
actual frequency: 60.0002 Hz
clock precision: 2^18
clock offset: 0.0000 ms
root delay: 0.00 ms
root dispersion: 0.00 ms
peer dispersion: 10.00 ms
reference time: 15:51:36.259 UTC Apr 25 2010(C6179088.426490A3)
Run the display ntp-service sessions [ verbose ] command to view the status of NTP sessions.
<Quidway> display ntp-service sessions
source reference stra reach poll now offset delay
disper
********************************************************************************
[12345]127.127.1.0 LOCAL(0) 7 1 64 2 - 0.0
15.6
note: 1 source(master),2 source(peer),3 selected,4 candidate,5 configured,
6 vpn-instance
3.5 Maintaining NTP
This section describes how to debug NTP through the debugging command in case of an NTP
operation fault.
3 NTP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
3-20 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)