Huawei Quidway S9300

1.13.2 Configuring the SNMP Version
After the SNMP version is disabled on the device, to enable the NMS to access the device through
SNMPv3, you need to configure SNMPv3 on the switch.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent sys-info version v3
The SNMP version is configured.
By default, SNMPv3 is configured.
----End
1.13.3 Creating a MIB View
By configuring different MIB views, you can configure different access authorities for NM
Stations.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent mib-view { excluded | included } view-name oid-tree
A MIB view is created.
----End
1.13.4 Configuring Authorities for the SNMP User Group
Context
Do as follows on the switch enabled with the SNMP agent.
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-42 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)