Huawei Quidway S9300

No. Data
3 FTP user name and password
4 (Optional) Source IP address of the FTP operation and VPN instance name and source
and destination port numbers of the FTP operation
5 Name or size of the uploaded file
6 Start mode and end mode of the test
6.7.2 Configuring the FTP Upload Test Parameters
This part describes how to set parameters for the FTP upload test.
Context
Do as follows on the NQA client (FTP client):
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type ftp
The test type is set to FTP.
Step 4 Run:
destination-address ipv4 ip-address
The destination IP address is configured.
Step 5 (Optional) Perform the following as required to configure other parameters for the FTP upload
test:
l To configure the source IP address, run the source-address ipv4 ip-address command.
l To configure the VPN instance to be tested, run the vpn-instance vpn-instance-name
command.
l To configure the source port, run the source-port port-numbercommand.
l To configure the destination port, run the destination-port port-number command.
l To configure the NQA test packet to be sent without searching the routing table, run the
sendpacket passroute command.
Step 6 Run:
ftp-operation put
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-16 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)