Applicable Environment
Through the SNMP Query test, you can obtain the statistics of the communication between hosts
and SNMP agents.
Pre-configuration Tasks
Before configuring the SNMP Query test, complete the following tasks:
l Configuring the SNMP agent
l Configuring routes between the NQA client and the SNMP agent
Data Preparation
To configure the SNMP query test, you need the following data.
No. Data
1 Administrator name and test name
2 IP address of the SNMP agent
3 (Optional) Source IP addresses and source port numbers of test packets, interval for
sending test packets, and percentage of the failed NQA tests
4 Start mode and end mode of the test
6.11.2 Configuring the SNMP Query Test Parameters
This part describes how to set SNMP query test parameters.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
test-type snmp
The test type is set to SNMP Query.
Step 4 Run:
destination-address ipv4 ip-address
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-28 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
