The primary URL is preferentially adopted during file upload. If the primary URL fails, the
secondary URL is used. If the secondary URL is also fails, the switch must wait for the next re-
upload interval to re-upload the statistics file.
----End
1.16.10 Enabling the Statistics File
After all parameters of the performance batch collection function are set, you can enable the
statistics file to collect the data needed by the NM Station.
Context
After statistics collection and statistics file upload are configured, you must enable the statistics
file so that statistics can be collected.
Do as follows on the switch.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bulk-file file-name
The bulk-file view is displayed.
Step 3 Run:
collect enable
The statistic file is enabled.
----End
1.16.11 Checking the Configuration
After the performance batch collection function is configured, you can view corresponding
parameters.
Prerequisite
The configurations of the Batch Statistics Collection are complete.
Procedure
Step 1 Run the display bulk-stat [ file-name ] command to check the information about the statistics
file.
----End
Example
Run the display bulk-stat command to check the information about the statistics file.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 1 SNMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-55
To Next Page
Loading...
Need help?
General
