The cluster view is displayed.
3. Run:
cluster-member unrelated-port [ group-by { device-type device-type | ip
{ip-address [ to ip-address ] } &<1-10> | member-number { member-number
[ to member-number ] } &<1-10> } ] { ndp | ntdp }
NDP or NTDP is disabled on unrelated interfaces.
– Only the last command execution result is saved.
– The member selection mode can be device type-based, member switch ID-based,
IP address-based, or all.
– This command can be performed only after the cluster is enabled.
----End
8.3.4 Checking the Configuration
After configuring advanced HGMP functions, you can view the configuration.
Prerequisite
The configurations of the Advanced HGMP are complete.
Procedure
l Run the display cluster-increment-result to check the delivery of incremental
configuration.
l Run the display cluster-license to check the cluster license.
l Run the display cluster-topology-info to check the cluster topology.
l Run the display increment-command to check the incremental configuration command.
l Run the display increment-synchronization-result to check whether configuration files
of member switches are synchronized to the FTP server.
l Run the display member-getfile-stat to check whether member switches successfully
obtain configuration files, version files, or patch files.
l Run the display member-interface-state { ndp | ntdp } to check the status of NDP or
NTDP on unrelated interfaces of member switches.
l Run the display member-reboot-stat to check whether member switches are restarted
successfully.
l Run the display member-save-stat to check whether member switches successfully save
the current configurations to the FTP server
l Run the display synchronization-result to check whether member switches successfully
synchronize configuration files to the FTP server.
----End
Example
If the incremental configuration command is successfully delivered to member switches, run the
display cluster-increment-result command, and you can view that success is displayed.
<HUAWEI_0.Quidway> display cluster-increment-result
The result of member switches executing increment commands:
------------------------------------------------------------------------------
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-28 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
