Huawei Quidway S9300

increment-command [ command-number command-number ] command-text command-
text
The command list is edited.
5. Run:
increment-run [ group-by { device-type device-type | ip { ip-address [ to
ip-address ] } &<1-10> | member-number { member-number [ to member-
number ] } &<1-10> } ]
The result whether commands in the command list are sent to the specified member
switch is displayed.
– Only the last execution result of the incremental configuration is saved.
– The member selection mode can be device type-based, member switch ID-based,
IP address-based, or all.
– If you use the ID of an existing command during the process of editing the
command list, the command will be overwritten.
– To delete the existed incremental configuration command, run the undo
increment-command { command-number command-number | all } command.
– To check the list of incremental configuration commands that is currently edited,
run the display increment-command command.
l Synchronizing configuration files
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
The cluster view is displayed.
3. Run:
increment-config synchronization [ group-by { device-type device-type |
ip {ip-address [ to ip-address ] } &<1-10> | member-number { member-
number [ to member-number ] } &<1-10> } ]
The result whether configuration files of the specified member switch are
synchronized to the FTP server is displayed.
– The member selection mode can be device type-based, member switch ID-based,
IP address-based, or all.
– This command is valid only after the cluster is enabled.
l Configuring security features
Do as follows on the administrator switch:
1. Run:
system-view
The system view is displayed.
2. Run:
cluster
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 8 HGMP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8-27