Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
snmp-agent usm-user v3 user-name group-name
Users are added into the SNMPv3 user group.
----End
1.10.5 Configuring a Basic ACL
This part describes how to configure ACLs to enable a specific NMS to access the device.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
acl acl-number
A basic ACL is created.
Step 3 Run:
rule [ rule-id ] { deny | permit } [ fragment | source { source-address source-
wildcard | any } | time-range time-name ]
*
ACL rules are defined.
----End
1.10.6 Applying the ACL
This part describes how to use ACLs to filter the source address of the NM Station user group.
Context
Do as follows on the switch enabled with the SNMP agent.
Procedure
Step 1 Run:
system-view
The system view is displayed.
1 SNMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
1-30 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
