No. Data
1 Administrator name and test name
2 Uni-directional transmission delay threshold
6.32.2 Configuring Uni-directional Transmission Delay Thresholds
This part describes how to set a one-way transmission delay threshold. When the transmission
duration exceeds the threshold, a trap message is sent to the NMS.
Context
Do as follows on the switch to perform the NQA test:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the NQA instance view is displayed.
Step 3 Run:
threshold owd-sd owd-sd-value
The uni-directional transmission (from the source to the destination) delay threshold is
configured.
Step 4 Run:
threshold owd-sd owd-sd-value
The uni-directional transmission (from the destination to the source) delay threshold is
configured.
----End
6.32.3 Checking the Configuration
After setting the one-way transmission delay threshold, you can view the configuration.
Prerequisite
The configurations of the Uni-directional Transmission Delay Thresholds Test function are
complete.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-123
To Next Page
Loading...
