3 NTP Configuration
About This Chapter
This chapter describes how to configure Network Time Protocol (NTP) to make clocks of the
devices on the network identical.
3.1 Introduction to NTP
This part describes the application and working principles of NTP.
3.2 NTP Supported by the S9300
This part describes NTP operating modes supported by the S9300.
3.3 Configuring Basic NTP Functions
This section describes how to configure basic NTP functions, including the NTP operating
modes.
3.4 Configuring NTP Security Mechanisms
This section describes how to configure NTP security mechanisms to guarantee reliable clock
synchronization on networks demanding high security.
3.5 Maintaining NTP
This section describes how to debug NTP through the debugging command in case of an NTP
operation fault.
3.6 Configuration Examples
This section provides several configuration examples of NTP.
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 3 NTP Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-1
To Next Page
Loading...
Need help?
General
