Huawei Quidway S9300

Pre-configuration Tasks
Before configuring test results to be sent to the FTP server, complete the following tasks:
l Configuring the FTP server
l Configuring a reachable route between the NQA client and the NM station
l Configuring a test instance
Data Preparation
To configure test results to be sent to the FTP server, you need the following data.
No. Data
1 IP address of the FTP server
2 User name and password used for logging into the FTP server
3 Number of test results saved through FTP
4 Duration of saving test results through FTP
6.34.2 Configuring Parameters for Connecting the FTP Server
This part describes how to set parameters for accessing the FTP server that receives the test
results, such as address of the FTP server and user name and password for accessing the FTP
server.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa-ftp-record ip-address ip-address
or
nqa-ftp-record vpn-instance vpn-instance
The IP address of the FTP server is configured.
Step 3 Run:
nqa-ftp-record username username
The user name for logging into the FTP server is configured.
Step 4 Run:
nqa-ftp-record password password
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-130 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)