EasyManuals Logo

Huawei Quidway S9300 User Manual

Huawei Quidway S9300
630 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
3.3.3 Configuring the Unicast Server/Client Mode
In C/S mode, the clock on the client synchronizes with the master clock on the server.
Procedure
l Configuring the NTP Client
Do as follows on the switch functioning as a client:
1. Run:
system-view
The system view is displayed.
2. (Optional) Run:
ntp-service source-interface interface-type interface-number [ vpn-
instance vpn-instance-name ]
The local source interface that sends the NTP packet is configured.
3. Run:
ntp-service unicast-server ip-address [ version number | authentication-
keyid key-id | source-interface interface-type interface-number | vpn-
instance vpn-instance-name | preference ] *
The IP address of the NTP server is configured.
Step 2 is optional. If source-interface is specified in Step 3, use it preferentially.
ip-address is the IP address of the NTP server. It can be the IP address of the host
rather than a broadcast address, a multicast address, or the IP address of the reference
clock.
NOTE
When the unicast NTP server is specified, the local switch functions as the client automatically.
The server needs to be configured with only a primary clock.
l (Optional) Configuring the Source Interface for the NTP Server to Send NTP Packets
Do as follows on the switch working as a client:
1. Run:
system-view
The system view is displayed.
2. Run:
ntp-service source-interface interface-type interface-number
The local source interface that sends NTP packets is specified.
Commonly, specify the IP address of the NTP server on the client. The client and
server can then exchange NTP packets using this IP address
If the source interface to send NTP packets is specified on the server, the IP address
of the server configured on the client should be the same; otherwise, the client cannot
process NTP packets sent from the server and clock synchronization fails.
----End
3 NTP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
3-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Huawei Quidway S9300 and is the answer not in the manual?

Huawei Quidway S9300 Specifications

General IconGeneral
BrandHuawei
ModelQuidway S9300
CategoryNetwork Router
LanguageEnglish

Related product manuals