Before configuring a PWE3 ping test for a single-hop PW, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
6.25.2 Configuring Parameters for the PWE3 Ping Test on a One-Hop PW
This part describes how to set PWE3 ping test parameters for a single-hop PW.
6.25.3 Checking the Configuration
After performing the PWE3 ping test for a single-hop PW, you can view the test result.
6.25.1 Establishing the Configuration Task
Before configuring a PWE3 ping test for a single-hop PW, familiarize yourself with the
applicable environment, complete the pre-configuration tasks, and obtain the required data. This
can help you complete the configuration task quickly and accurately.
Applicable Environment
To check the connectivity of the one-hop pseudo wire (PW) using LDP as the signaling protocol,
you can perform the PWE3 Ping test on the one-hop PW.
Pre-configuration Tasks
Before configuring the PWE3 Ping test on a one-hop PW, you must correctly configure the
dynamic one-hop PW.
Data Preparation
To configure the PWE3 Ping test on a one-hop PW, you need the following data.
No.
Data
1 ID of the PW
2 Type of the PW
3 Type and number of the interface connected with the CE
4 Destination IP address and ID of the L2VC
5 (Optional) Response mode of the Echo-Request packets, LSP EXP, maximum hops,
number of probes, TTL value, and timeout period of the packets
6 Start mode and end mode of the test
6.25.2 Configuring Parameters for the PWE3 Ping Test on a One-
Hop PW
This part describes how to set PWE3 ping test parameters for a single-hop PW.
Context
Do as follows on the NQA client:
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management 6 NQA Configuration
Issue 03 (2010-09-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-95
To Next Page
Loading...
Need help?
General
