mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
l Configuration file of Member-3.
#
sysname Member-3
#
vlan batch 10
#
cluster enable
ntdp enable
ntdp hop 3
ntdp timer 10
ndp enable
#
interface Vlanif10
#
interface gigabitethernet1/0/2
port link-type trunk
port trunk allow-pass vlan 10
ntdp enable
ndp enable
#
cluster
mngvlanid 10
administrator-address 0001-0001-0001 name HUAWEI
#
return
8.5.8 Example for Configuring the Incremental Configuration
Function for an HGMP Cluster
Networking Requirements
As shown in Figure 8-10, all the Layer 2 switches belong to the same cluster. Administrator-1
is the administrator switch of the cluster and other switches are member switches. The member
ID of Member-2 is 2 and the member ID of Member-3 is 3.
To configure VLAN 100 to VLAN 200 on Member-2 and Member-3 and a static route with its
next hop address being the administrator switch, you can use the incremental configuration
function of the HGMP cluster.
8 HGMP Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
8-104 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
