No. Data
1 Administrator name and test name
2 NQA events that trigger the trap function
3
l (Optional) Number of test failures that trigger sending a trap message
l (Optional) Number of probe failures that trigger sending a trap message
6.33.2 Sending Trap Messages When Test Failed
A trap message is sent to the NMS when the transmission of NQA test packets fails.
Context
Do as follows on the NQA client:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
nqa test-instance admin-name test-name
An NQA test instance is created and the test instance view is displayed.
Step 3 Run:
send-trap testfailure
Sending trap messages when tests fail is enabled.
By default, the trap function is disabled.
Step 4 Run:
test-failtimes times
The number of test failures that trigger sending a trap message is configured.
By default, a trap message is sent for each test failure.
----End
6.33.3 Sending Trap Messages When Probes Failed
A trap message is sent to the NMS when the NQA test fails.
Procedure
Step 1 Run:
system-view
6 NQA Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - Network Management
6-126 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2010-09-20)
To Next Page
Loading...
Need help?
General
