17-19 Operators’ Manual
990400 Rev C 2010 May 1
Published by Imaging Sciences International
This Operators’ Manual contains original instructions by Imaging Sciences
International for the safe use of the i-CAT 17-19. Imaging Sciences
International reserves the right to make changes to both this Operators’
Manual and to the products it describes. Equipment specifications are
subject to change without notice. Nothing contained within this manual is
intended as any offer, warranty, promise or contractual condition, and must
not be taken as such.
This document may not, in whole or in Part, be copied, photocopied,
reproduced, translated, or reduced to any electronic medium or machine-
readable form without prior consent in writing from Imaging Sciences
International.
i-CAT
®
is a registered trademark of Imaging Sciences International. Other
names may be trademarks of their respective owners.
No part of this document may be reproduced or transmitted in any form or
by any means, electronic or mechanical, for any purpose, without prior
written permission of Imaging Sciences International. Names and data used
in examples herein are fictitious unless otherwise noted. The software
program described in this document is provided to its users pursuant to a
license or nondisclosure agreement. Such software program may only be
used, copied, or reproduced pursuant to the terms of such agreement. This
manual does not contain or represent any commitment of any kind on the
part of Imaging Sciences International.
To Next Page
Loading...