17-19 Operators’ Manual
990400 Rev C 2010 May 1
16-2
Import Installation and Setup
If the PDI.dll has not been installed, place the PDI.dll in the same
folder where the VisionQ.exe resides. The PDI.dll must be in place
before setup can continue.
Determine which interface type, DICOM Worklist or PM, is to be
used for import, and follow the appropriate setup procedure below.
Set Up DICOM Worklist Interface
1. Start VisionQ.
2. From the VisionQ Main menu, select File > New Patient.
PDI Service
Class User
VisionQ
(1) “Process”
command
issued
(2) Request issued
(3) Request received
(4) Patient data sent
(5) Response received
Remote
Server
To Next Page
Loading...