D-2
17-19 Operators’ Manual
990400 Rev C 2010 May 1
Symbol Descriptions Locations Symbol Descriptions Locations
Breaker Switch On/
Off
Rear Overhead Interlock Fuse Rear Overhead
Output for Interlock Rear Overhead X-Ray Supply Fuse Rear Overhead
AC In Rear Overhead Fuse Rear Overhead
Manufactured For
Manufactured By
Model No.
Serial No.
Tube Head
Assembly, X-Ray
Power Supply, X-
Ray Controller,
Beam Limiter, Rear
Overhead, Leg
Continuous:
Intermittent
Rear Overhead, X-
Ray Power Supply
Label Location
Emergency Stop Patient Emergency Stop
Caution: This X-ray unit may be dangerous to patient and operator unless safe exposure
factors and operating procedure are observed. Unauthorized use is prohibited.
Control Box
Caution: Laser Radiation Do Not Stare Into Beam
<1mW 635nm Class II Laser Product
X-Ray Source
Caution Laser Radiation Do Not Stare Into Beam
<1mW 670nm Class II Laser Product
Gantry
Maximum Lifting Capacity
<
182 KG (<400 Lbs)
Chair Assembly
Warning Pinch Point
Keep Hands Clear
Seat Weighs 6.8 KG (15 lbs)
Seat Assembly
Modes of Operation: Continuous & Intermittent Rear Overhead
Warning Pinch Point
Keep Hands Clear
Chair Gate
Modes of Operation: Continuous & Intermittent
Complies with IEC 60601-2-7 and IEC 60601-2-28
Capacitor Has >300VDC
Wait 5 Minutes for Capacitor Discharge before Handling
Do Not Use Grounded Test Equipment on this Unit
X-Ray Power Supply
Do Not Use with i-CAT Scan
Only Use with i-PAN Scan
Push to Release Label
i-PAN Head Positioner
To Next Page
Loading...