iZ Technology RADAR - Page 178

iZ Technology Corporation
RADAR 3.50
REFERENCE
171
Shortcut keys (sets format and rate):
Session Controller + (TC PREF)
KC-24 +
Use the TC RATE dialogue to select a frame rate for the
current project.
RADAR supports all standard timecode rates including:
• 30 fps
• 30 fps drop frame
• 29.97 fps
• 29.97 fps drop frame
• 25 fps
• 24 fps
• 23.976 fps
From this dialogue, choose a fast or slow lock speed
when chasing timecode. In most situations the FAST
setting will be the best choice. However, with jittery or
poor quality timecode, the SLOW setting provides
smoother tracking of the incoming timecode at the
expense of lock time.
SMPTE FREEWHEEL time is the number of frames of
bad or missing timecode that will be tolerated before
dropping out of chase mode. The possible values for this
dialogue range between 0 and 10 frames.
This dialogue enables and disables the output of a static
timecode value when the RADAR transport is stopped.
STATIC TC OUT is useful in certain situations where
other machines need to know the position of the RADAR
at all times.
TC SETTINGS:
STATIC TC OUT
TC SETTINGS:
FREEWHEEL TIME
TC SETTINGS:
SMPTE LOCK SPEED
TC SETTINGS:
TC RATE