www.izcorp.com • 1.800.776.1356
The CHASE MODE setting determines the behavior of
RADAR
when in chase. The following options are
available:
In RECHASE mode RADAR will locate, lock and begin
playback, continually comparing its position with that of
the incoming timecode.
In LOCK-AND-DROP mode RADAR will locate, lock,
begin playback and release. Lock and Drop behavior is
recommended when chasing poor or damaged timecode,
and for line recording.
In NUDGE mode, if the timecode drifts, the clock speed
will be temporarily adjusted to bring the timecode back in
sync, and therefore relies primarily on the timecode
source. This setting is recommended when chasing MTC
and set to internal sync.
Displays the number of samples of drift between
RADAR’s clock and the incoming timecode in the offset
window of RADARView.
This feature determines the default amount of sync drift
that RADAR can accommodate during CHASE mode
before dropping out and re-syncing. WILD is 10X
NORMAL mode.
Enables RADAR to automatically start chasing timecode
once RADAR is powered up and a project is loaded.
TC SETTINGS:
CHASE ON POWERUP
TC SETTINGS:
SYNC THRESHOLD
TC SETTINGS:
SHOW SYNC DRIFT
TC SETTINGS:
CHASE MODE
To Next Page
Loading...
